Descripción

• 8 × 10/100 Mbps PoE ports,2 × Gigabit RJ45 port
• Total PoE Power Budget 60 W
• Support 802.1Q VLAN
• Support PoE watchdog to detect and restart the cameras that do not respond
• Support STP/RSTP Loop prevention
• Support cable detection to locate failure
• Up to 300 m Long Range PoE Transmission
• 6 kV Surge Protection

• General
• CarcasaMetal material
• Peso neto0.54 kg (1.19 lb)
• Peso bruto1.08 kg (2.38 lb)
• Dimensiones (W x H x D)217.6 mm × 27.6 mm × 108.5 mm (8.57' × 1.09' × 4.27')
• Temperatura de funcionamiento0 °C to 40 °C (32 °F to 104 °F)
• Temperatura de almacenamiento-40 °C to 85 °C (-40 °F to 185 °F)
• Condiciones de humedad5% to 95% (no condensation)
• Humedad relativa5% to 95% (no condensation)
• Fuente de alimentaciónDC54 V,1.2 A
• Modo de instalaciónDesk-Mounted,Wall-Mounted
• Max. El consumo de energía65 W
• Consumo de energía en inactivo5 W
• Surge Protection6 kV

• Parámetros de red
• Puertos8 × 10/100 Mbps PoE port,2 × Gigabit RJ45 port
• Tabla de direcciones MAC4 K
• Capacidad de conmutación

  Whole-Device Performance: 9.6 Gbps

  Port Performance: 5.6 Gbps

• Tasa de reenvío de paquetes

  Whole-Device Performance: 7.14 Mpps

  Port Performance: 4.17 Mpps

• Caché interna2 Mbits

• Fuente de alimentación PoE
• PoE StandardIEEE 802.3af,IEEE 802.3at
• Pin de alimentación PoEEnd-span: 1/2(-), 3/6(+)
• Puerto PoEPoE: Ports 1 to 8
• Max. Puerto de alimentación30 W
• PoE Power Budget60 W

• Función de software
• Largo alcance

  Ports 1 to 8: up to 300 m.

  Long range performance may vary depend on camera model or cable condition.

• Port Isolation

  Ports 1 to 8: port isolation mode to improve network security

  Ports in an isolation group cannot communicate with each other, but they can communicate with ports outside the isolation group.

• PoE WatchdogPorts 1 to 8: auto detect and restart the cameras that do not respond.
• Loop Prevention

  Loop prevention is used to prevent the switching network from forming loops, which will seriously affect network communication. Disabled by default.

  Support 802.1D STP.

  Suppport 802.1w RSTP.

• VLAN

  VLAN is used for network scale planning and network health improvement.

  Support 802.1Q.

  Configurable VLAN ID from 1-4094.

  Support Trunk, Access port mode.

  Support Max. 4094 VLAN.

• HPP

  Support one-click activation and remote management via Hik-Partner Pro. Functions supported:

  1. Display the port rate.

  2. Display the port bandwidth utilization rate.

  3. Display the PoE power usage.

  4. Display topology information.

  5. Display the alarm status.

  6. Restart ports and devices.

  7. Enable port long-rage mode.

  8. Remotely upgrade the device.

• System Maintenance

  Support device management via web.

  Support DHCP Client. Enabled by default for dynamic assignment of management IP addresses.

  Support Super IP, which is a fixed IP address (10.180.190.200) for direct access.

  Support management via Hik-Central Pro.

  Support remote management via Hik-Partner Pro.

  Support cable detection.

  Supports 802.1ab LLDP for peer device discovery.

  Support port mirroring for fault locating.

• Certificaciones
• EMCCE-EMC (EN 55032: 2015+A11: 2020, EN IEC 61000-3-2: 2019, EN 61000-3-3: 2013+A1: 2019, EN 50130-4: 2011+A1: 2014, EN 55035: 2017+A11: 2020)
• SeguridadCB (IEC 62368-1)
• QuímicaCE-RoHS (2011/65/EU); WEEE (2012/19/EU); Reach (Regulation (EC) No.1907/2006)